Installation guide

5. Remove the driver CD, shutdown Windows, and

setup your RAID array.

When Windows resumes, go to SATARaid5 GUI on

page 19 and install the RAID monitoring utility.

Windows XP/Server 2003 (64-bit)

For A New Installation

A new installation requires a floppy disk for the driver

installation. To make this floppy disk, copy the contents

of the 64bit folder, found on the driver CD, onto a blank

floppy disk then follow the directions below.

1. Setup the RAID array prior to Windows installation.

2. Follow Microsoft procedure to install Windows

accordingly.

3. At the Windows Setup screen, press F6 to continue.

Note: Prior to this step, you may be prompted to

restart in order to continue with the installation.

4. Insert the driver diskette. Press S then press Enter.

5. Select Silicon Image SiI... Controller (64-bit

Extended) and press Enter.

6. Press Enter to continue and follow on-screen

instructions to complete the installation.

When Windows installation completes, go to SATARaid5

GUI on page 19 and install the RAID monitoring utility.

For An Existing Installation

1. Install the board and boot up Windows.

2. At the Found New Hardware Wizard:

For XP (w/SP1 or earlier)/Server 2003: go to step #3.

For XP (w/SP2 or later)/Server 2003 (w/ SP1 or later):

select No, not this time, then click Next.