Installation guide

2. During boot press Ctrl+S or F4 to enter the RAID

BIOS.

3. Select Create RAID set then press Enter.

4. Select SPARE DRIVE then press Enter.

5. Select the replacement drive then press Enter.

6. When asked Are You Sure (Y/N)?, press Y to confirm.

7. Press Ctrl+E to exit.

8. When asked Are you sure to exit (Y/N)?, press Y to

exit.

Note: If during restart the RAID BIOS reports an

incomplete RAID set, disregard the message,

continue booting, and let the Mirror rebuild.

RAID 10 (Mirror+Striping)

This RAID set is used on New/Blank hard drives, do not

use existing hard drive(s) with data. To create a Mirrored-

Striped set four hard drives are required.

For Manual Configuration

1. As the BIOS boots press Ctrl+S or F4 when prompted

to enter the RAID BIOS.

2. At the next screen select Create RAID Set, then

press Enter.

3. Select RAID10 then press Enter.

4. Select Manual configuration, then press Enter.

5. Select chunk size from 4k, 8k, 16k, 32k, 64k or 128k,

then press Enter.

6. Select the first drive, press Enter.

7. Select the second drive, press Enter.

8. Select the third drive, then press Enter.