Installation guide

3
1. Turn OFF the power to your computer and any
other connected peripheral devices.
2. Unplug the power cord from the back of the
computer.
3. Remove the computer cover.
4. Remove the slot bracket from an available PCI slot.
5. To install the card, carefully align the card bus
connector to the selected PCI slot on the
motherboard. Push the board down firmly, but
gently, until it is well seated.
6. Replace the slot bracket holding screw to secure the
card.
Device Connection
The Serial ATA PCI is a dual channel Serial ATA controller
that supports up to two Serial ATA hard disk drives. If
you plan to use the second Serial ATA channel, you will
need to purchase another Serial ATA cable.
1. Install hard disk drive(s) in chassis.
2. Connect the Serial ATA hard disk drive to the system
power supply using the Serial ATA power cable.
3. Connect one end of the Serial ATA cable to the hard
disk drive.
Figure 2: Hard disk drive connecrions
4. Attach the other end of the Serial ATA cable to the
Serial ATA connector on the Serial ATA PCI.
Serial ATA cable
Serial ATA power
cable