Installation guide

To Verify Windows NT4.0 Installation

1. Double click My Computer/Control Panel/SCSI

Adapters.

2. Highlight Silicon Image... Controller from SCSI

Adapters listing and click Properties. A message

This device is working properly is displayed in the

dialog box when the driver is correctly installed.

Windows 2000

For New Windows 2000 Installation

A new installation of Windows 2000 requires a floppy

disk for the driver installation. To make this floppy disk,

copy the contents of the Floppy folder, found on the

driver CD, onto a blank floppy disk then follow the

directions below.

1. Install the board and follow Microsoft procedures

to install Windows 2000 accordingly.

2. Restart your system when prompted during

Windows' installation.

3. At the Windows 2000 Setup screen, press F6 to

install the driver.

4. Insert the driver diskette. Press S, then press Enter.

5. Select Silicon Image SiI... Controller and press

Enter.

6. Press Enter to continue and follow on-screen

instructions to complete the installation.

For Existing Windows 2000 Installation

1. Install the board and boot up Windows 2000.

2. At the Found New Hardware Wizard, click Next.

3. Select Search for a suitable driver for my device

(recommended) and click Next.