Datasheet

All the connection and installation works are to be
performed only after the fan disconnection from
power supply network.
While connecting the fan to the power supply
network keep the clearance between the dead
contacts not less than 3 mm for all poles.
Air flow direction in the system must match the
pointer direction on the fan casing.
fans are mounted into the
ventilation ducts on both sides and clamped.
Other fan models are installed into the air duct hole
and fixed to the wall or ceiling with dowels.
Take measures to prevent free access to the fan
impeller and other parts under voltage using such
protecting devices at outlet as ventilation grille,
protecting cowl etc.
Location of the fan parts is shown in fig. 1-9.
Connection sequence of the fans is shown in tab.2
INSTALLATION AND PREPARATION
FOR OPERATION
Attention!
SIKU1/SIKU2/SIKU3
For the fans not equipped with a pull cord switch we recommend to
install the power switch in the fixed wiring system.
Wiring diagram for connection the fan to the fixed power supply wiring
system is shown in fig. 10-14.
table 2
SIKU 1
SIKU 2
SIKU 3
SIKU 100 PF
SIKU 125 PF
SIKU 150 PF
Fan model
Connection of fans to electric power supply
Remove the ventilation grille (except for
model). Take away the protecting cowl. Lead the
power supply cords through a hole 3, strip the wire leads
for 7-8 mm and insert those to the terminal blocks 4
against stop inside the metal part of the terminal and
tighten them with screws. Fix the cords with the retaining
clamp clip 2. Reinstall the protecting cowl and the grille back.
SIKU 1/SIKU 2/
SIKU 3
Remove the protecting grille. Lead the power supply cords
through a hole 3, strip the wire leads for 7-8 mm and
insert those to the terminal blocks 4 against stop inside
the metal part of the terminal and tighten them with
screws. Fix the cords with the retaining clamp clip 2.
R connect the fan with the protecting grille back.e
Remove the protecting grille. Lead the power supply cords
through a hole 3 which should be cut before in the plastic
wall. Strip the wire leads for 7-8 mm and insert those
to the terminal blocks 4 against stop inside the metal part
of the terminal and tighten them with screws. Place the
power supply cords into the casing slots and fix them in
the wire fixing racks. Reinstall the cover and the protecting
grills back.
SIKU 100 M
SIKU 125 M
SIKU 150 M
SIKU 100 AZ
SIKU 125 AZ
SIKU 150 AZ
SIKU 100 S
SIKU 125 S
SIKU 150 S
SIKU 100 LD
SIKU 125 LD
SIKU 150 LD
EN