User Manual

• Where dirt or dust could collect and block the sensor
• Where it could be knocked, damaged, or inadvertently removed
Good Transmission Path:
A good transmission path must be established from the proposed
mounting location before permanently installing the detector. To check,
perform the test described in the testing signal strength section.
Mounting Procedure:
Once a suitable location is found, mount the detector as follows:
1. Refer to the diagram below and install the mounting base on the
ceiling or on the wall (if local ordinances permit) using screw lo-
cations “A” or “B” as required. Use the two screws and anchors
provided. Maneuver the base so the screws are at the elbow of the
screw slots and secure.
2. Fit the detector inside the base by aligning it over the base as shown
(detector’s alignment notch should be slightly offset from mounting
base tamper release tab), then turn the detector in a clockwise direc-
tion until it clicks into place.
3. Test the detector after completing the installation (as described in
the TESTING THE DETECTOR section of this manual) and refer to
the control system’s instructions for additional information concern-
ing the use of wireless devices.