User Manual

GENERAL INFORMATION:
Before installing detectors, please thoroughly read these installation
instructions. For detailed information on detector spacing, placement,
zoning, wiring, and special applications refer to current edition of the
NFPA 72 National Fire Alarm and Signaling Code.
NOTICE: These instructions should be left with the owner/user of this
equipment.
IMPORTANT: This detector must be tested and maintained regularly
following NFPA 72 requirements. Test detector operation weekly. The
detector should be cleaned at least once a year.
NOTE: CO Detectors have a limited life. CO detectors should be replaced
immediately if not operating properly. You should always replace a CO
detector after 6 years from date of purchase.
NOTE: Remove battery tab before installation.
NOTE: Radio Frequency device operates at 418MHz
WARNING: This product is intended for use in ordinary indoor
locations of family living units. It is not designed to measure
compliance with Occupational Safety and Health Administration (OSHA)
commercial or industrial standards. Individuals with medical problems
may consider using warning devices which provide audible and visual
signals for carbon monoxide concentrations under 30ppm.
FCC ID: PPJCO5SS418