User`s guide

23FocalPoint™ Receivers Gateway Installation & Operation Manual - P/N: 53251:Rev: A 9/8/09
Section 3 Receivers Gateway Installation and
Configuration
3.1 Receivers Gateway Installation Overview
The sequence in which these tasks are performed is determined by the Admin User performing
them and this list is a suggested guideline.
1. Install Receivers in desired locations (refer to individual Receiver manuals).
2. Setup these supported digital receiver(s).
• “ADEMCO 685 Setup” on page 12.
• “Radionics D6600 Setup” on page 14.
• “Silent Knight 9500/9800 Receiver Setup” on page 17.
• “Teldat VisorALARM Receiver Setup” on page 20.
3. Start the FocalPoint Workstation software applications. Refer to “Workstation Startup” on
page 23 and “Receivers Gateway Startup” on page 24.
4. Use the Receivers Gateway to configure network communications settings. Refer to
“Receivers Gateway Network Communication Configuration” on page 24.
System Limitations
Each instance of the Receivers Gateway can support a maximum of 20 receivers.
3.2 Workstation Startup
Refer to the Workstation manual or to “Login” on page 28 for more details.
Step 1. Select Start > >All Programs >Facilities Monitoring >Workstation.
Step 2. From the Workstation menu bar select File > Login. The User Login window displays.
Step 3. Click on a User name with system administrator privileges.
Step 4. Type the user’s password into the Password field and then click OK.
NOTE: The Workstation and FPT Receivers Gateway must be logged into before any of its
settings can be configured. A User that has the Security Option to configure settings needs to
login to change an existing setting. The factory defined User “Admin” has such an Security
Option. Information in this document is written assuming that a User with the equivalent Security
Option of the “Admin” User will be performing the procedures in this document.