User's Manual

FCC Notice
This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
List of applicable FCC rules
This device complies with below part 15 of the FCC Rules.
Part 15 Subpart C
Test Modes
silex technology, Inc. uses various test mode programs for test set up which operate separate from
production firmware. Host integrators should contact silex technology, Inc. for assistance with test
modes needed for module/host compliance test requirements.
Additional testing, Part 15 Subpart B disclaimer
The modular transmitter is only FCC authorized for the specific rule parts (i.e., FCC transmitter rules)
listed on the grant, and the host product manufacturer is responsible for compliance to any other FCC
rules that apply to the host not covered by the modular transmitter grant of certification.
The final host product still requires Part 15 Subpart B compliance testing with the modular transmitter
installed.
RF exposure considerations
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment
and meets the FCC radio frequency (RF) Exposure Guidelines as this equipment has very low levels of
RF energy.
Co-Location Rule
This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.