User's Manual

2-2
You will see a screen that looks like this:
5. Click on Search and select the EtherWind from the list to and click
Configure.
6. You will be prompted for a password, this is the configuration password
(default password is ACCESS). The Wireless Server Configuration screen
will appear:
7. The EtherWind you selected in the will configure itself to the same wireless
settings of the wireless network being used through the configuration utility, so
you should NOT need to change the Wireless Mode, RF Channel, SSID, and
Data Rate settings unless you want to change the EtherWind to a different
wireless network, or if you need to enable WEP. If you are using DHCP on
your network, the EtherWind will have acquired valid IP Address settings at
this point, and no further configuration should be required for the IP Boot
Method, IP Address, Subnet Mask, and Gateway fields. From this screen, you
can configure the IP Address settings and the Print Server name. A description
of each settings is listed below. Once these are all set, click OK or Apply.