User's Manual

EtherWind Connectors, Switches, and LEDs
Test Switch. Press down this switch for less than 5 seconds to print a test page on
the printer. The test page will show the current wireless and network settings of
the EtherWind wireless print server. Press it down for more than 5 seconds to reset
the EtherWind to its factory default parameters. To enable console mode on the
serial port, hold in the test switch while powering on the Serial Server (see next
section for additional details).
Power Connector. Plug the power supply into this connector.
LED status indicators. The yellow light stays lit when you have made a wireless
connection to the EtherWind from a computer or access point. The green light
blinks whenever data is transmitted over the wireless link.
Parallel Port (DB25). This port is used for connecting to a parallel printer.
Serial Port (DB9). This port is used for connecting a serial printer or other serial
device. Can also be used to access the command line console of the EtherWind for
configuration and diagnostics.
1-2
Test Switch
Serial Port (DB9)
Parallel Port (DB25)
Power Connector
LED Status
Indicators