User's Manual

ManualsBrandsSilex Technology ManualsElectronicsSDIO Wireless Module

Table Of Contents

PF-SDMGN Users Manual

June 25, 2012

PF-SDMGN Users Manual

1. Hardware specifications/Compliance

...................................................2

2. System Requirements (for the install)

..................................................5

3. Setup

..............................................................................5

1/

Summary of content (5 pages)

PAGE 1
PF-SDMGN Users Manual June 25, 2012 PF-SDMGN Users Manual 1. Hardware specifications/Compliance ...................................................2 2. System Requirements (for the install) ..................................................5 3. Setup ..............................................................................
PAGE 2
PF-SDMGN Users Manual 1. Hardware specifications/Compliance FCC ID：N6C-PFSDMGN IC No：4908B-PFSDMGN NOTICE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
PAGE 3
PF-SDMGN Users Manual This radio transmitter (identify the device by certification number, or model number if Category II) has been approved by Industry Canada to operate with the antenna types listed below with the maximum permissible gain and required antenna impedance for each antenna type indicated. Antenna types not included in this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device.
PAGE 4
PF-SDMGN Users Manual Operating environment ： Temperature：-20℃ to +85℃, -4F to +185F Humidity：20% to 85% Storage environment ： Temperature：-40°C to +90°C, -40F to +194F Humidity：20% to 85% supply voltage ： 3.3V ± 5% Host I/F ： SDIO V2.0 IEEE802.11b ： Frequency : 2412MHz~2462MHz Transmission system ： DS-SS Transmission speed： 1M/2M/5.5M/11M Automatic detection Channel：1－11ch IEEE802.
PAGE 5
PF-SDMGN Users Manual 2. System Requirements (for the install) ・A Personal computer or the embedded architecture that have SDIO V2.0 ・32 MB memory or greater(Recommend) ・300 MHz processor or higher(Recommend) 3. Setup (One of the methods) It uses Driver and a utility of Atheros Communications.