Specifications

7-10Functions for Configuration
SATO Users Manual
TCP/IP Configuration
Tab
TabTab
Tab Explanation
ExplanationExplanation
Explanation
Factory
FactoryFactory
Factory
Default
DefaultDefault
Default
Enable/Disable TCP/IP protocol operations. This
has influence on the configuration of Setup Tools,
LPR, FTP, TELNET, SNMP, HTTP and other
protocols over TCP/IP.
ENABLE
Enable/Disable DHCP/BOOTP protocol
operations. DHCP/BOOTP is a protocol, via
which IP address gets assigned by the BOOTP
server or DHCP server. If you use DHCP/BOOTP
server, the DHCP/BOOTP server must be in the
same segment as the print server. This print
server detects DHCP and BOOTP automatically.
If more than 1 address get returned, the IP
address which is returned first will be used.
ENABLE
Enable/Disable RARP protocol operations. RARP
is a protocol, via which IP address gets assigned
by the RARP server. If you use RARP server, the
RARP server must be in the same segment as the
print server.
ENABLE
Setting the Print Server IP address. The IP
address must be 4 numbers, each between 0-255
(eg. 192.168.100.10).
0.0.0.0
Setting the print server subnet mask. The subnet
mask must be 4 numbers, each between 0-255
(eg. 255.255.255.0). However, entering 0.0.0.0
would not be valid, and the subnet mask
corresponding to the IP address would be used
automatically.
0.0.0.0
Item
ItemItem
Item
Use TCP/IP Protocol
Use DHCP/BOOTP
Use RARP
Subnet Mask
TCP/IP
IP Address