Specifications

8-2Questions & Answers
SATO Users Manual
LAN board is not found even after searching in the configuration utility
(Quick Setup, AdminManager) or LAN board is not recognized in the network
CHECK1
Check the followings and retry the configuration.
-If the printer for internal LAN board type is turned on or LAN board power is turned on.
-Print the self-diagnostic and configuration report. If NG is printed, refer to "NG is printed
in the diagnostic report....." on page 3 of this chapter.
-If the parameters are configured correctly.
-If the LINK LED of LAN board and the Ethernet HUB are blinking. If not, check the
proper network cable connection.
-If the Ethernet HUB is working properly.
NOTE
-For printing self-diagnostic/configuration report, refer to chapter 1.
CHECK2
Check the following and retry the configuration.
CHECK3
When operating in Windows environment, run AdminManager and click
Option , then
search using TCP/IP protocol. When operating in NetWare environment, click Search
using IPX/SPX protocol
, and search LAN board again.
CHECK4
When you use TCP/IP protocol in Windows XP environment, click
Local Area
Connection Properties,
then Advanced , then remove the check from Protect my
computer and network by limiting or preventing access to this computer from
the Internet.