Specifications

8-3Questions & Answers
SATO Users Manual
NOTE
SOLUTION
If your problems still continues after Check 1, 2 and 3, initialize LAN board to factory
default and retry the configuration corresponding to your network environment.
-For initializing LAN board to factory default, refer to chapter 1.
Unable to print self-diagnostic report
CHECK1
Make sure that the printer is ready for printing. (Online, Interface type etc.)
CHECK2
Check the printer data receive lamp.
If it is lighting, off-line the printer and press the eject button.
NG is printed in self-diagnostic report
CHECK
Check if the following applies before turning on LAN board or printer.
-Check the proper connection between LAN board and printer when you find NG in
ROM or RAM.
-When you find NG in EEPROM check, the you may have improper connection between
LAN board and printer or improper Dip switch settings.
-When you find NG in NIC check, check the proper connection of the network cable.