User Manual

8
Preparing the WT-4
Introduction
Preparing the WT-4
Attach the Antenna
Attach the supplied antenna to the WT-4 as
shown in the diagram.
Inserting the Battery
To power the camera when the WT-4 is in place, insert the camera
battery into the WT-4 battery chamber or use an optional AC
adapter. The WT-4 takes one EN-EL3e rechargeable Li-ion battery;
other batteries can not be used. To ensure that transmission is not
interrupted during setup or upload, be sure the battery is fully
charged. Note that the drain on the battery is increased when the
WT-4 is attached.
1 Open the battery chamber cover.
2 Insert the battery as shown on
the inside of the battery
chamber cover.
• Make sure the battery is
oriented corrrectly when
inserting. Push the battery
latch toward the outside with
the side of the battery and insert the battery until the
battery latch locks the battery securely in place.
• See the battery and battery charger manuals for details on
battery recharging and other precautions.
Battery latch
$00_WT-4_En.book Page 8 Friday, August 10, 2007 2:02 PM