User Manual

81
Thumbnail select mode / Connecting the WT-4
Operating the WT-4 for Computer
Connecting the WT-4
Before connecting the WT-4, select [MTP/PTP] for the [USB] option
in the camera setup menu (pg.7) and confirm that the host
computer is running.
1 Turn the camera off and insert the
memory card containing the pictures to
be sent.
• If there are multiple card slots, insert
the card into any slot.
To access the network via Ethernet, connect the Ethernet
cable (pg.2). Note that wireless transfer is disabled while an
Ethernet cable is connected. Disconnect the Ethernet cable
before accessing a wireless network. Turn the WT-4 off before
connecting or disconnecting the Ethernet cable.
2 Open the WT-4 USB connector cover and
connect the USB cable from the WT-4 to
the camera USB connector.
3 Turn the camera on.
4 Select [Thumbnail Select mode] for the
[Wireless transmitter] > [Mode] option in
the camera setup menu (pg.152).
DUMMY
Front
U
MMY
$00_WT-4_En.book Page 81 Friday, August 10, 2007 2:02 PM