User Manual

94
PC Mode / Controlling the Camera
Operating the WT-4 for Computer
Controlling the Camera
1 Complete the steps in “Connecting to the Computer” (pp.90–
93).
2 Start Camera Control Pro 2 on the host
computer and confirm that “PC” is
displayed in the camera control panel.
3 Control the camera as described in the Camera Control Pro 2
manual. Any photographs taken while the camera is
connected will be recorded directly to the computer hard disk.
4 Turn off the WT-4
When the POWER LED (pg.3) changes
from green to yellow and then goes
out, detach the USB cable.
D Wireless Networking
Compared with Ethernet networking, wireless networking may involve
time delays between operations.
D Ethernet Networks: Do Not Disconnect the Ethernet Cable
Do not disconnect the Ethernet cable while the camera is on.
A Wireless Networks: Loss of Signal During Transfer
A loss of signal may interrupt the connection while pictures are being
transferred to Camera Control Pro 2. If the POWER LED on the WT-4 is
blinking (pg.2), turn the WT-4 off and then on again. Transfer will resume
when the connection is re-established. Do not turn the camera off.
Transfer can not be resumed once the camera has been turned off.
$00_WT-4_En.book Page 94 Friday, August 10, 2007 2:02 PM