User Manual

Copying Network Profiles to the Camera / Ad Hoc Networks

Operating the WT-4 for Computer

9 Enter the following information and click [Next].

• Network name (SSID): Enter a network name or choose from a

list of existing networks. Do not change the name if it is

supplied automatically.

• Network type: Select [Ad hoc].

• Channel: Select a communication channel. However, if the

network name (SSID) is consistent, a predetermined channel

separate from the channel set here may be applied.

• Authentication: Choose the type of authentication used on the

network. In ad-hoc mode, the camera supports open system

and shared key authentication.

• Encryption: The type of encryption used on the network.

Choose from [None] (open networks only), 64-bit WEP, and

128-bit WEP.

• Encryption key: If the network uses encryption, enter the

network key. The number of characters required depends

on the type of key used:

• Key Index: Set the key index when [WEP64] or [WEP128] is set

for [Encryption]. The default index is [1]. Setting the key

index is not necessary when [No encryption] was selected

for [Encryption].

WEP (64-bit) WEP (128-bit)

Number of characters (ASCII) 513

Number of characters (hex) 10 26

$00_WT-4_En.book Page 54 Friday, August 10, 2007 2:02 PM