User's Manual

Safety and Regulatory Notices Silex Page 71
Part Number 140-00188-180
Appendix D
Safety and Regulatory Notices
Information for United States Users (SX-500 & SX-510)
This equipment has been tested and found to comply within the limits for a Class B digital device
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio and television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver,
 Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
 Consult the dealer or an experienced radio/TV technician for help.
The user is cautioned that changes and modifications made to the equipment without the approval of
manufacturer could void the user’s authority to operate this equipment.
Operation is subject to the following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may cause
undesired operation.
The radiated output power of the print server is far below the FCC radio frequency exposure limits.
Nevertheless, print server shall be used in such a manner that the potential for human contact during
normal operation is minimized.
To satisfy RF exposure requirements for the SX-500, this device and its antenna(s) must operate with a
separation distance of at least 20 centimeters from all persons and must not be co-located or operating in
conjunction with any other antenna or transmitter. End-users must be provided with specific operating
instructions for satisfying RF exposure compliance.
The SX-510 satisfies the FCC Part 15C rules for Specific Absorption Rate (SAR). The SAR limit set by
the FCC is 1.6 W/kg (Watts/kilogram). These limits are part of comprehensive guidelines to establish
permitted levels of Radio Frequency energy for the general public. The highest body SAR value for the
SX-510 is 0.41 W/kg. The SX-510 is not intended for placement next to the head and the 20 cm
separation rule should be used.