Owner's Manual

Chapter 1 Getting Started 5
3. Place the Li-Ion battery pack in the compartment.
Make sure the symbols on the battery pack label align
with the symbols inside the compartment.
4. Replace the door and tighten the screws.
5. Plug the AC wall power charger that came with the
Archer 3 into a wall socket. Plug the other end into
the DC power jack on the Archer 3. The red LED on
the keypad blinks when the battery pack is charging.
Charge the battery pack for 4-6 hours at room
temperature.
Attach the Stylus Tether
A capacitive stylus and tether are included with the
handheld.
Note: A stylus is not required to use the touchscreen. The
optimal way to make selections is by nger touch.
One end of the tether is attached to the stylus. To attach it
to the hand strap, follow these steps:
Line the symbols up
on the case and the
battery pack as shown