User Manual

In addition, Access Point 3241 has a hole in the bottom of the unit. Trough that hole user can press a button. If

that button is pressed while the unit is powered on, configuration is reset to factory defaults.

There is no power switch in Access Point 3201 or 3241. The adapter is the disconnection device; the socket-outlet shall be

installed near the equipment and shall be easily accessible. Unplug and plug the power adapter to switch the power on and

off. The power led in figure above is on when the power adapter is connected.

All the blue status leds are turned off and the status led number 1 blinks on four second intervals when the boot

procedure is finished and the unit is ready to be connected. Led number 2 is led which blinks quicklyBluetooth

every 30 seconds indicating service activity.Bluetooth

2.1.2 Access Server AX4 connectors

The physical interface locations of Access Server AX4 are described in figures below.

There is no power switch in Access Server AX4. The adapter is the disconnection device; the socket-outlet shall be

installed near the equipment and shall be easily accessible. Unplug and plug the power adapter to switch the power on and

off. The power led in figure below is on when the power adapter is connected.

All the blue status leds are turned off and the status led number 1 blinks on four second intervals when the boot

procedure is finished and the unit is ready to be connected. Bluetooth led, (led number 4) blinks quickly every 30

seconds indicating service activity.Bluetooth

Access Server AX4 has microSD card slot, factory reset button and SIM card slot (for optional, integrated

Figure : Physical interfaces of Bluegiga Access Point1

Figure : Physical interfaces of Bluegiga Access Server AX42

Figure : Access Server AX4 leds3