User's Manual
Table Of Contents
- 1. Feature List
- 2. Ordering Information
- 3. System Overview
- 4. Electrical Specifications
- 4.1 Electrical Characteristics
- 4.1.1 Absolute Maximum Ratings
- 4.1.2 Operating Conditions
- 4.1.3 Current Consumption
- 4.1.4 Wake up times
- 4.1.5 Brown Out Detector
- 4.1.6 Frequency Synthesizer Characteristics
- 4.1.7 2.4 GHz RF Transceiver Characteristics
- 4.1.8 Oscillators
- 4.1.9 Flash Memory Characteristics
- 4.1.10 GPIO
- 4.1.11 VMON
- 4.1.12 ADC
- 4.1.13 IDAC
- 4.1.14 Analog Comparator (ACMP)
- 4.1.15 I2C
- 4.1.16 USART SPI
- 4.2 Typical Performance Curves
- 4.1 Electrical Characteristics
- 5. Typical Connection Diagrams
- 6. Layout Guidelines
- 7. Pin Definitions
- 8. BGM113 Package Specifications
- 9. Certifications
- 10. Revision History
- Table of Contents
As long as the conditions above are met, further transmitter testing will not be required. However, the OEM integrator is still responsible
for testing
their end-product for any additional compliance requirements required with this module installed (for example, digital device
emissions, PC peripheral requirements, etc.).
Note: In the event that this condition cannot be met (for certain configurations or co-location with another transmitter), then the FCC
authorization is no longer considered valid and the FCC ID cannot be used on the final product. In these circumstances, the OEM inte-
grator will be responsible for re-evaluating the end product (including the transmitter) and obtaining a separate FCC authorization.
End Product Labeling
The BGM113 Module is labeled with its own FCC ID. If the FCC ID is not visible when the module is installed inside another device,
then the outside of the device into which the module is installed must also display a label referring to the enclosed module. In that case,
the final end product must be labeled in a visible area with the following:
"Contains Transmitter Module FCC ID: QOQ-BGM113"
or
"Contains FCC ID: QOQ-BGM113"
The OEM integrator must not provide information to the end user regarding how to install or remove this RF module or change RF
related parameters in the user manual of the end product.
To comply with FCC RF radiation exposure limits for general population, the antenna(s) used for this transmitter must be in-
stalled such that a minimum separation distance of 0 mm is maintained between the radiator (antenna) and all persons at all
times and must not be co-located or operating in conjunction with any other antenna or transmitter.
BGM113 Blue Gecko Bluetooth
®
Smart Module
Data Sheet
Certifications
silabs.com | Smart. Connected. Energy-friendly. Preliminary Rev. 0.93 | 65