User's Manual
Table Of Contents
- 1. Key Features
- 2. Pinout
- 3. Interfaces
- 4. Module Software
- 5. Hardware Design Guidelines
- 6. Electrical Characteristics
- 7. RF Characteristics
- 8. Physical Dimensions and PCB Land Pattern
- 9. Soldering Recommendations
- 10. Tape and Reel Packaging
- 11. Certifications
- 12. Ordering Information
- 13. Support
- 14. Revision History
- Table of Contents
Figure 3.1. Recommended Schematics: Connecting WGM110 with an External Host Using the UART Interface (USART0 Loc 0)
Note: In the figure above the UART interface is wired using USART0 Location 0 pins.
Note: If handshaking is required, then connect external host CTS to PE13 and external host RTS to PE12.
Note: A programming connector, as shown in the schematics, must be available in the design to enable WGM110 firmware update.
3.1.2 SPI
SPI is one of the available host interfaces on the WGM110 Module. SPI must be always enabled and configured by the user, because it
is not enabled or configured as default.
The table below shows the features of the SPI host interface:
Table 3.2. SPI Host Interface Features
Parameter Features (value ranges)
SPI mode SPI slave
Bit rates 9600 bps - 6 Mbps
Bit order MSB first
Clock polarity and phase Configurable
Supported USARTs USART0 and USART1
Supported locations All locations
Host protocol BGAPI serial protocol
WGM110 Wizard Gecko Wi-Fi
®
Module Data Sheet
Interfaces
silabs.com | Smart. Connected. Energy-friendly. Rev. 1.2 | 9