User's Manual

Team2 SW help
5. Open software preferences (Tools > Preferences) and select the Base station/USB
dongle tab. Click Add below the base station list, the secondary base station is added to
the base station list. NOTE: It may take up to 1 minute until the Add button is enabled
after the secondary base station is connected to the PC.
6. Switch off the secondary base station and unplug the Ethernet cable, if you want to
introduce another secondary base station. Then follow the steps 3-5.
7. After you have introduced secondary base stations (one or two) to the system, you will
have to synchronize the transmitters with the new base station combination. See
instructions in How to synchronize transmitters with new base stations
.
In order the secondary base stations work, the main base station must be on and connected to
the PC. Only the main base station connects to the PC, the secondary base stations connect to
the system via the main base station. If the secondary base stations are introduced to the system,
they connect to the main base station wirelessly, automatically, after switching on.
NOTE: If the base station has been previously introduced to any Team
2
or Cardio GX system (as
a main or secondary base station), it must be reset before it can be introduced to the system (as
a main or secondary base station) again. See instructions in How to reset base station
.
How to Introduce USB Dongle
If the USB dongle has not been plugged in during Wizard, it cannot be used as an alternative for
the base station because the Team
2
doesn't recognize the USB dongle. Before the USB dongle
can be used for transferring data from the transmitters' memory to the PC, it has to be introduced
to the system. It can be done according to the following steps:
1. Open the Team
2
PC software.
2. Plug in the USB dongle into the free USB port.
3. Open the base station / USB dongle settings tab in software preferences (Tools >
Preferences > Base station/USB dongle tab).
27