- Silicon Laboratories, Inc. Modem User Manual

AN93
Rev. 1.3 85
32 UK CID State Tone Alert
Signal detected
STAS XXXXX X
33 Overcurrent condition X
5
XXXXX X
40
Blacklist is full BLACKLIST FULL (enabled
via S42 register)
XXXXX X
41
Attempted number is black-
listed.
BLACKLISTED (enabled via
S42 register)
XXXXX X
42
No phone line present NO LINE (enabled via %Vn
commands)
XXXXX X
43
Telephone line is in use LINE IN USE (enabled via
%Vn commands)
XXXXX X
44
Polarity reversal detected POLARITY REVERSAL
(enabled via G modifier)
XXXXX X
45
Polarity reversal NOT
detected
NO POLARITY REVERSAL
(enabled via G modifier)
XXXXX X
52 Link established at 56000 CONNECT 56000
6
XXXX X
60 Link established at 32000 CONNECT 32000
6
XXXX X
61 Link established at 48000 CONNECT 48000
6
XXXX X
63 Link established at 28000 CONNECT 28000
6
XXXX X
64 Link established at 29333 CONNECT 29333
6
XXXX X
65 Link established at 30666 CONNECT 30666
6
XXXX X
66 Link established at 33333 CONNECT 33333
6
XXXX X
67 Link established at 34666 CONNECT 34666
6
XXXX X
68 Link established at 36000 CONNECT 36000
6
XXXX X
69 Link established at 37333 CONNECT 37333
6
XXXX X
70 No protocol PROTOCOL: NONE Set with \V0 command.
75 Link established at 75 CONNECT 75 X X X X X
77 V.42 protocol PROTOCOL: V42
7
Set with \V0 command.
79 V.42bis protocol PROTOCOL: V42bis
3
Set with \V0 command.
Table 43. Result Codes (Continued)
Numeric
1
Meaning Verbal Response X0 X1 X2 X3 X4 X5
Notes:
1. Numeric mode: Result code <CR>.
2. Response for ATDn@mmm is silence is not found.
3. This message is supported only on the Si2493, Si2457, Si2434, and Si2415.
4. This message is supported only on the Si2493, Si2457, and Si2434.
5. X is not preceded by <CR><LF>.
6. This message is supported only on the Si2493 and Si2457.
7. V.44 with data compression disabled (+DS = 0) emits this result code.
8. If data compression is disabled (+DS = Q), the modem returns the message PROTOCOL:V42.