- Silicon Laboratories, Inc. Modem User Manual

AN93
86 Rev. 1.3
80
MNP2 protocol PROTOCOL:
ALTERNATE, +CLASS 2
Set with \V command.
81
MNP3 protocol PROTOCOL:
ALTERNATE, +CLASS 3
Set with \V command.
82
MNP4 protocol PROTOCOL:
ALTERNATE, +CLASS 4
Set with \V command.
83
MNP5 protocol PROTOCOL:
ALTERNATE, +CLASS 5
3
Set with \V command.
84 V.44 protocol PROTOCOL: V.44
8
Set with +DR command
90 Link established at 38666 CONNECT 38666
6
XXXX X
91 Link established at 40000 CONNECT 40000
6
XXXX X
92 Link established at 41333 CONNECT 41333
6
XXXX X
93 Link established at 42666 CONNECT 42666
6
XXXX X
94 Link established at 44000 CONNECT 44000
6
XXXX X
95 Link established at 45333 CONNECT 45333
6
XXXX X
96 Link established at 46666 CONNECT 46666
6
XXXX X
97 Link established at 49333 CONNECT 49333
6
XXXX X
98 Link established at 50666 CONNECT 50666
6
XXXX X
99 Link established at 52000 CONNECT 52000
6
XXXX X
100 Link established at 53333 CONNECT 53333
6
XXXX X
101 Link established at 54666 CONNECT 54666
6
XXXX X
102 DTMF dial attempted on a
pulse dial only line
UN-OBTAINABLE NUMBER X X X X X X
Table 43. Result Codes (Continued)
Numeric
1
Meaning Verbal Response X0 X1 X2 X3 X4 X5
Notes:
1. Numeric mode: Result code <CR>.
2. Response for ATDn@mmm is silence is not found.
3. This message is supported only on the Si2493, Si2457, Si2434, and Si2415.
4. This message is supported only on the Si2493, Si2457, and Si2434.
5. X is not preceded by <CR><LF>.
6. This message is supported only on the Si2493 and Si2457.
7. V.44 with data compression disabled (+DS = 0) emits this result code.
8. If data compression is disabled (+DS = Q), the modem returns the message PROTOCOL:V42.