User`s guide

Si47xx-EVB
Rev. 0.8 43
5.4. FM Transmitter Main Window
The FM transmitter main window will appear after initialization.
Figure 38. FM Transmitter Main Window
Table 8. FM Transmitter Main Window Descriptions
# Description Range
1
Transmit frequency display. Enter the desired FM transmit frequency in this window.
76–108 MHz
2
Transmit voltage display. Enter the desired FM transmit voltage in this window.
88–120 dBuV
3
Varactor Value. This is an indicator showing the tuning cap value of the Si472x device.
Each number represents 0.25 pF. If the varactor value is manually overwritten in the
property window, the indicator will change from automatic mode to manual mode.
1–191
4
RF on or off. Selecting this checkbox will enable the FM transmit, while turning this but-
ton off will disable the FM transmit.
On/Off
5
Pre-Emphasis. Click one of the three buttons to set the pre-emphasis either to Off, 50 µs
or 75 µs.
Off, 50 µs, 75 µs
6
Si472x EVB audio input setting indicator: Analog In/Digital (Analog In to CODEC)/Digital
(SPDIF).
Analog, Digital
CODEC, Digital
SPDIF
7
Presets. Press and hold the desired preset button for 1.5 seconds to program. The cur-
rent frequency will replace the preset number. Press for less than 1.5 seconds to tune to
the displayed frequency. Presets can also be programmed automatically from the
Receive Power Scan window.
76–108 MHz
8
Pilot Tone Generation. Set to 19 kHz and select "Pilot On" when in stereo mode. Set to
0–19 kHz for and select "Pilot On" for test tone generation.
0–19 kHz
9
Audio Deviation. Enter the desired audio deviation in this window.
0–90 kHz
10
Pilot Deviation. Enter the desired pilot deviation in this window.
0–90 kHz
1
2
3
4
5
6
7
8
9
11
10
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26