User guide

Default Jumper Settings
AC701 Evaluation Board www.xilinx.com 79
UG952 (v1.1) January 30, 2013
Default Jumper Settings
The AC701 board default jumper configurations are listed in Table A-3.
Table A - 3 : AC701 Default Jumper Settings
Header Jumper Description
Schematic
Page
2-pin
J11 1-2 XADC VCCINT 4A range 34
J53 1-2 XADC_VCC5V0 = 5V 29
J9 1-2 REF3012 XADC_AGND L3 bypassed 29
J10 1-2 REF3012 XADC_AGND = GND 29
J63 None Voltage Regulators Enabled 38
J52 None Test Header, Not a Jumper 7
J5 1-2 EPHY U12.2 CONFIG2 = LOW 15
J8 1-2 VCCO_VADJ (FMC) Voltage = ON 45
J3 None SPI SELECT = On-Board SPI Device 4
J6 1-2 SFP+ Enabled 20
3-pin
J35 1-2 EPHY U12.3 CONFIG3 = HI 15
J36 None EPHY U12.2 CONFIG2 Option Header 15
J37 None EPHY U12.3 CONFIG3 Option Header 15
J43 2-3 XADC_VCC = ADP123 1.85V 29
J54 2-3 REF3012 V
IN
= XADC_VCC 29
J42 1-2 XADC_VREFP = REF3012 XADC_VREF 29
J38 1-2 SFP RX BW = FULL 20
J39 1-2 SFP TX BW = FULL 20
2x2
J12 3-4 PCIE Lane Width = 4 28