Reference Manual

RS9116 B00 TRM Addendum for Compliance and Certification v1.0, Jan-2021
silabs.com | Building a more connected world. Rev 1.0 3 | Page
PRELIMINARY | Subject to change.
This device complies with Industry Canada license-exempt RSSs. Operation is subject to the following two
conditions:
1) This device may not cause interference, and
2) This device must accept any interference, including interference that may cause undesired operation of
the device.
Le present appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de
licence. L’exploitation est autorisee aux deux conditions suivantes :
1) l’appareil ne doit pas produire de brouillage;
2) l’utilisateur de l’appareil doit accepter tout brouillage radioelectrique subi, meme si le brouillage est
susceptible d’en compromettre le fonctionnement.
1.2.1 Labeling and User Information
Innovation, Science and Economic Development Canada ICES003 Compliance Label: CAN ICES-3 (B)/NMB-
3(B)
The RS9116 - B00 module has been labeled with its own IC ID number (8407A-B001P5V2P1) and if the IC ID
is not visible when the module is installed inside another device, then the outside of the finished product into
which the module is installed must also display a label referring to the enclosed module. This exterior label can
use following wording: Contains Transmitter Module IC : 8407A-B001P5V2P1 or Contains IC : 8407A-
B001P4V2P1 User manuals for license-exempt radio apparatus shall contain the above mentioned statement or
equivalent notice in a conspicuous location in the user manual or alternatively on the device or both
Le module RS9116 - B00 a été étiqueté avec son propre numéro d’ID IC (8407A-B001P5V2P1) et si l’ID IC
n’est pas visible lorsque le module est installé dans un autre périphérique, alors l’extérieur du produit fini dans
lequel le module est installé doit également afficher une étiquette faisant référence au module inclus. Cette
étiquette extérieure peut être libellée comme suit: Contient le module émetteur IC: 8407A-B001P4V2P1 ou
contient IC: 8407A-B001P5V2P1. Les manuels d'utilisation d'appareils radio exemptés de licence doivent
contenir l'énoncé susmentionné ou une notification équivalente à un endroit bien en évidence dans le manuel
d'utilisation. ou alternativement sur l'appareil ou les deux
1.3 Regulatory Module Integration Instructions
List of applicable FCC rules
This device complies with part 15.247 of the FCC Rules.
Summarize the specific operational use conditions
This module can be used in household electrical appliances as well as lighting equipment(s). The input voltage to
the module should be nominally 1.8-3.3 Vdc, typical and the ambient temperature of the module should not exceed
85℃. This module using two kinds of antennas, PCB antenna with maximum gain is 1.00 dBi. Other antenna
arrangement is not covered
Limited module procedures
Not applicable
Trace antenna designs
Not applicable
RF exposure considerations
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20cm between the radiator and your body. If
the device built into a host as a portable usage, the additional RF exposure evaluation may be required as
specified by§ 2.1093.by this certification. The antenna is not field replaceable. If the antenna needs to be changed,
the certification should be re-applied.
Antennas
Provision for Chip Antenna or other Antennae