User Guide

ManualsBrandsSILICON LABS ManualsStarter KitSILICON LABS UG432 BGM220P Wireless Gecko Module Starter Kit

4.3 BGM220P Reset

The BGM220P Module can be reset by a few different sources:

• A user pressing the RESET button

• The on-board debugger pulling the #RESET pin low

• An external debugger pulling the #RESET pin low

In addition to the reset sources mentioned above, a reset to the BGM220P will also be issued during board controller boot-up. This

means that removing power to the board controller (unplugging the J-Link USB cable) will not generate a reset, but plugging the cable

back in will, as the board controller boots up.

UG432: BGM220P Wireless Gecko Module Starter Kit User's Guide

Power Supply and Reset

silabs.com | Building a more connected world. Rev. 1.0 | 15

Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.