Instruction manual
Table Of Contents
- Additional Tools and Software
- Using the Command Line Configuration Utility (hdhomerun_config)
- Supported Commands
- HTTP Streaming (TECH3-6CC-3x2 only)
- Lineup file (TECH3-6CC-3x2 only)
- Datacast operation
- Using /sys/boot
- Setting the channel map
- Multicast
- Example Boot Script Configurations
- Tuning 2 ATSC channels and streaming to multicast addresses using RTP:
- /tuner0/channelmap us-bcast
- /tuner0/channel 31
- /tuner0/program 3
- /tuner0/target rtp://239.255.1.1:59001
- /tuner1/channelmap us-bcast
- /tuner1/channel 8
- /tuner1/program 1
- /tuner1/target rtp://239.255.1.2:59002
- Tuning 3 digital cable channels using a CableCARD and streaming to multicast addresses using RTP:
- /tuner0/vchannel 702
- /tuner0/target rtp://239.255.1.1:59001
- /tuner1/vchannel 740
- /tuner1/target rtp://239.255.1.2:59002
- /tuner2/vchannel 771
- /tuner1/target rtp://239.255.1.3:59003
- Tuning 2 DVB-T channels in Australia and streaming to multicast addresses using UDP:
- /tuner0/channelmap au-bcast
- /tuner0/channel 5
- /tuner0/program 20121
- /tuner0/target udp://239.255.1.1:59001
- /tuner1/channelmap au-bcast
- /tuner1/channel 44
- /tuner1/program 28753
- /tuner1/target udp://239.255.1.2:59002
- Tuning 2 DVB-C channels in Europe and streaming to a single PC, ignoring rejection messages from the PC due to a closed port:
- /tuner0/channelmap eu-cable
- /tuner0/channel 646
- /tuner0/program 231
- /tuner0/target udp://192.168.0.22:59001 no_clear
- /tuner1/channelmap eu-cable
- /tuner1/channel 770
- /tuner1/program 24112
- /tuner1/target udp://192.168.0.22:59002 no_clear
- HDHomeRun QuickTV (Windows)
- VideoLAN VLC
- TSReader
Datacast operation
TECH3 units support Datacast TCP/IP over OTA broadcast. Datacasting often provides news, weather,
traffic, stock market, and other information which may or may not relate to the program[s] it is carried
with. An electronic program guide is usually included. Datacast TCP-IP packets are reassembled and
then routed to the LAN port.
Example:
Discover the device:
hdhomerun_config discover
Set the physical channel:
hdhomerun_config FFFFFFFF set /tuner0/channel auto:651000000
Set the datacast PID:
hdhomerun_config FFFFFFFF set /tuner0/filter 0x0A00
Set the target:
hdhomerun_config FFFFFFFF set /tuner0/target datacast