Specifications

Page 8
Copyright 2006 Robert A. Larson, KC9ICH
HEADPHONE JACK
A standard 1/4 inch diameter headphone plug will mate with the rear panel mounted headphone jack. A closed circuit jack is used
which will disconnect the speaker when the headphone plug is inserted. Headphones with an impedance of 600 ohms or less should
be used.
ACCESSORY POWER RECEPTACLES
Two rear panel mounted power receptacles provide 117VAC for accessory equipment only when the unit is powered from an AC
source. The one labeled “1I7VAC SW.” is connected through the front panel power switch and will be used for equipment that is to
be turned on and off with the 1011D. Note that the maximum available current limit is 1 ampere. Equipment requiring no more than
3 amperes maximum may be connected to the other receptacle.
Equipment connected to this receptacle will not be switched off with the 1011D but will have power applied whenever the line cord
from the rear panel of the 1011D is plugged into an AC source.
CAUTION
Do not connect equipment to these receptacles when the Model 14A, 12 volt converter is used to power the 1011D. Damage to such
equipment from over voltage will result.
Figure 2. SILTRONIX MODEL 1011D REAR VIEW