User Manual

Relay SG 3
FCC and Government Guidelines
z Reorient or relocate the receiving antenna.
z Increase the separation between the equipment and receiver.
z Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
z Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation.
Any changes or modifications to this device not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
In order to maintain compliance with FCC RF exposure requirements, this device must be
installed in such a manner as to maintain a 20 cm separation distance between the antenna and
all persons.
FCC regulations require that this unit be professionally installed and maintained by a trained
meter technician. Use of an antenna other than that outlined in the FCC certification filing may
violate FCC regulations.
Labelling
Figure 2 is a copy of the FCC ID label that can be found affixed to the Relay SG. The size of the
label is 1.75 x 3.50 inches.
Figure 2. FCC, IC Label