eBridge Labeling Integrator's Guide Silver Spring Networks DW_EDIT_SSN - Bridge FCC Labeling 080208.
eBridge Labeling Integrator's Guide 1 Introduction The Silver Spring Networks eBridge is a FCC Part 15.247 compliant device that enables communication between Silver Spring Networks AMI network and intelligent endpoint device (IED) connected to either the serial or Ethernet port of the eBridge. The eBridge transmits in the 902 to 928 MHz, ISM band and transfers data from the IEDs to Silver Spring Networks Access Points, Relays and/or other continuous power device acting as network relays.
eBridge Labeling Integrator's Guide Figure 3. The size of the label is 1.5” x 1.0” inches. The barcode format is Code 3 of 9. Figure 1 – FCC & Part Number Label for eBridge PCBA SSN PN 123-456789 FCC ID: OWS-NICxxx IC: 5975A-NICxxx This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
eBridge Labeling Integrator's Guide Figure 3. The barcode format is Code 3 of 9.
eBridge Labeling Integrator's Guide Figure 3 – Top Side of eBridge PCBA Figure 4 – Bottom Side of eBridge PCBA Silver Spring Networks 5
eBridge Labeling Integrator's Guide FCC and Government Guidelines Silver Spring Networks eBridge FCC ID: OWS-NIC506 IC: 5975A-NIC506 The eBridge is REQUIRED to be professionally installed within the host IED by a properly trained technician. Improper installation could void the user’s authority to operate the equipment. Figure 5 – Sample Label for eBridge PCBA FCC ID: OWS-NIC506 IC: 5975A-NIC506 This device complies with Part 15 of the FCC Rules.
eBridge Labeling Integrator's Guide 2.1 FCC Guidelines for Devices Containing a Transmitter Module The following is an extract from FCC PART 15 UNLICENSED MODULAR TRANSMITTER APPROVAL, DA 00-1407, Released: June 26, 2000, Section 6 describing labeling requirements for devices containing a modular transmitter. Section 6.