NIC 510 and Meter Labeling Product Requirements Silver Spring Networks 555 Broadway Street Redwood City, CA 94063 www.silverspringnet.
NIC 510 and Meter Labeling Product Requirements Confidential Information of Silver Spring Networks®, Inc., provided under nondisclosure obligations. Copyright © 2015 Silver Spring Networks, Inc. All rights reserved.
NIC 510 and Meter Labeling Product Requirements 1 1 About the Silver Spring Networks Network Interface Card, NIC 510 About the Silver Spring Networks Network Interface Card, NIC 510 The Silver Spring Networks NIC 510 is a network interface card that enables machine-to-machine communication over 900 MHz and 2.4 GHz ISM bands. Figure 1. Silver Spring meter NIC References Guidelines for 64-bit Global Identifier (EUI-64™) Registration Authority, IEEE Standards Association.
NIC 510 and Meter Labeling Product Requirements 1 About the Silver Spring Networks Network Interface Card, NIC 510 NIC Address Labeling For radio identification, the host device shall have an auxiliary label containing the Silver Spring Networks NIC address presented in text (16 alphanumeric digits) and bar code formats. • Bar Code Type = Code 3 of 9 • Bar Code Font Size = unknown • Font Type = unknown • Font Size = unknown • Bar Code Label Dimensions = 1.0ʺ x 1.
NIC 510 and Meter Labeling Product Requirements 1 About the Silver Spring Networks Network Interface Card, NIC 510 Figure 4 shows the placement of the labels. Figure 4.
NIC 510 and Meter Labeling Product Requirements 2 2 FCC and Industry Canada Government Guidelines FCC and Industry Canada Government Guidelines Silver Spring Networks meter NIC FCC ID: OWS-NIC511-03 IC: 5975A-NIC51103 Table 1. NIC models Model No. 900 MHz 2.
NIC 510 and Meter Labeling Product Requirements 2 FCC and Industry Canada Government Guidelines This equipment has been tested and found to comply with Part 15 of the FCC Rules. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
NIC 510 and Meter Labeling Product Requirements 2 FCC and Industry Canada Government Guidelines application for equipment authorization, or, must provide adequate instructions along with the module which explain this requirement. In the latter case, a copy of these instructions must be included in the application for equipment authorization. The following is an extract from RSS-GEN, General Requirements and Information for the Certification of Radio Apparatus, Section 3.2.
NIC 510 and Meter Labeling Product Requirements 2 FCC and Industry Canada Government Guidelines NIC 510 External Antenna Integration This radio transmitter 5975A-NIC51103 has been approved by Industry Canada to operate with the antenna types listed Table 2 with the maximum permissible gain and required antenna impedance for each antenna type indicated.
NIC 510 and Meter Labeling Product Requirements 2 FCC and Industry Canada Government Guidelines • The information contained in this document is intended to aid qualified personnel, and is not a replacement for the proper training required to make a person qualified. • Silver Spring Networks assumes no liability for the customerʹs failure to follow these safety guidelines.