English English CE STATEMENT WARNINGS This device has been tested and found to comply with the requirements set up in the council directive on the approximation of the law of member states relating to EMC Directive 89/336/EEC, Low Voltage Directive 73/23/EEC and R&TTE Directive 99/5/EC. Use of non-original accessories may result in performance deterioration, injury, product damage, electronic shock and warranty termination.
English English CONTENTS CE STATEMENT................................................................................................. 1 TRADEMARK INFORMATION........................................................................... 1 READ THIS FIRST.............................................................................................. 1 WARNINGS......................................................................................................... 2 CAUTIONS......................................
English English GETTING STARTED Charging the Battery The headset comes with a built-in rechargeable battery. For first time use, it takes about 4 hours to fully charge the battery. Afterwards, it will take approx. 2 hours to become fully charged. With the battery fully charged, the talk time is up to 4,5 hours, and the standby time is up to 100 hours. Battery Indicator The red LED indicator on the headset will flash slowly when the battery is low.
English NOTE: It is highly recommended to first read your mobile phone's user manual before doing so. 1. The headset must be powered off before initiating the pairing process. After that, press and hold the S1 button for at least 5 seconds until the blue and red LED indicators on the headset start flashing alternately. 2. Tell your mobile phone to scan for other Bluetooth devices. 3. Your mobile phone will show you now all devices it has discovered during the scanning process.
English IMPORTANT INFORMATION About Pairing Troubleshooting What is Pairing? 1. The red LED indicator on the headset flashes. The headset is low on battery. Charge the headset for 2 hours until the red LED indicator on the adapter turns off. Pairing is a process of associating Bluetooth devices with one other. It will establish a permanent, secure link between the devices and enable quick access to the services provided without the need to enter any passkeys. 2.
English FREQUENTLY ASKED QUESTIONS Q: Why doesn't the headset work with my mobile phone after the headset has been fully charged and switched on? A: You need to enable the Bluetooth function of your mobile phone first and pair the mobile phone with the headset. Q: Does the headset work with all types of mobile phones? A: No. It works only with Bluetooth-enabled mobile phones. Q: What is the operating range between the headset and a Bluetooth mobile phone? A: The headset has been tested and approved by BQB.