Operation Manual

The SW SEN. switch on the left side of the device can be used to improve the
reception quality for the SW band. Select LX for strong stations and DX to
improve reception for weak stations.
The telescopic aerial does not work in the MW and LW bands. In these
bands, the radio uses its built-in ferrite aerial.
• Align the radio for best reception.
Memory functions
Save station
The world receiver can save 400 stations in each frequency range.
To store a station, proceed as follows:
• Set the frequency range with the frequency selection switch and then
the station that you want to save.
• Press the
MEM button. The screen shows the PAGE memory page and
MEM flashes.
• Within 10 seconds press the
PAGE button (the PAGE message flashes),
and then select a memory page (from 00–39) using the
UP or DOWN
button.
• Within 10 seconds use the
M.0/5–M.4/9 buttons to select a memory
space to store the station. For example, press the
M.0/5 button once
for memory space 0 and again for memory space 5. The occupancy
is shown on the screen.
• Press
MEM again to save the station. The PAGE and MEM messages
are shown on a permanent basis.
Note:
If the world receiver is connected to the mains adapter and no batte-
ries have been inserted, the station memories are lost when the adap-
ter plug is pulled from the socket.
- 84 -
IB_KH2030_DT25841_LB5 12.01.2009 17:26 Uhr Seite 84