Operation Manual

- 20 -
MP3-SYSTEM KH2302
Intended Use
This device is intended for the reception of FM/AM
radio stations, as well as for the playback of Audio
CDs and MP3 files from CDs, USB data carriers and
SD/MMC memory cards. This device is intended
for use only in domestic settings. It is not suitable
for use in commercial or industrial applications.
Technical data
This consumer electronics device, being in con-
formity with their fundamental requirements
and directions, complies with the relevant
regulations of both the EMC Guidelines
2004/108/EC and the Guidelines for Low
Voltage devices 2006/95/EC.
Power supply: AC 220 V - 240 V
~
50 Hz
Power consumption : 28 Watts
Nominal power: 4.5 watts RMS at 8 ohm
per channel
Standby: approx. 6 W
Operating temperature range: +5° - +40°C
Humidity: 5 — 90%
(no condensation)
Micro System Dimensions
(without consoles mounted)
(L x B x H): 320 x 192 x 75 mm
Loudspeaker Dimensions
(L x B x H): 130 x 160 x 205 mm
Micro System Weight: approx. 2.1 kg
Loudspeaker Weight: approx. 2.2 kg
Protection class: II/
Max. Output Voltage
(Headphone Connection): 70-80 mV
CD player
Playback formats: CD, CD-R, CD-RW
Radio frequency ranges:
Radio: MW (AM): 522 – 1620 KHz
VHF (FM): 87.5 - 108 MHZ
USB slot
Readable USB
memory sticks: USB 1.1 and 2.0 up to a
capacity of 2 GB
Memory card slot
Readable memory cards:
SD (2 GB), MMC (2 GB)
Subject to technical changes.
Safety instructions
• This device is not intended for use by individuals
(including children) with restricted physical, physio-
logical or intellectual abilities or deficiences in
experience and/or knowledge unless they are
supervised by a person responsible for their safety
or receive from this person instruction in how the
device is to be used.
• Children should be supervised to ensure that
they do not play with the device.
• Keep batteries away from children. Children can
put batteries into their mouths and swallow them.
If a battery is swallowed medical assistance must
be sought IMMEDIATELY.
To avoid potentially fatal electric shocks:
• Connect the device only to correctly installed
and earthed mains sockets. Ensure that the rating
of the local power supply tallies completely with
the details given on the rating plate of the device.
• Ensure that the power cable never becomes wet
or damp during operation. Lay the cable so that
it cannot be trapped or otherwise damaged.
IB_KH2302_DT42354_LB5 13.01.2009 15:01 Uhr Seite 20