Operation Manual

SilverCrest LCD 24-9 Wide
110
English
to switch it on. When the device is powered on, the front panel
power indicator (5) will light blue.
3. Turn on your computer. The user interface of your operating
system should appear on-screen.
Powering Off
1. To power the LCD 24-9 Wide off, press the
1
POWER button
(6) on the front panel of the device. This will turn the LCD 24-9
Wide to Standby mode and the power indicator (5) on the front
panel will stop lighting.
2. In order to turn off the Standby mode also, use the main power
switch button (7).
If no input signal is available (PC powered off or
signal cable not connected properly) the message “No
Signal” will appear. The device will then toggle to
Suspend mode and the power indicator (5) will light
orange.
Setting the Picture Resolution
After powering on your monitor and PC, the user interface of your
operating system should appear on-screen. Your SilverCrest LCD
24-9 Wide should detect the currently set resolution automatically.
However, this does not necessarily have to match the maximum
supported resolution of your monitor. In order to obtain the best
picture quality, you should set the recommended resolution of
1920 x 1080 (max. refresh rate: 60 Hz).
In the following there is a guide on how to adjust the resolution for
the Windows
®
XP and Windows Vista™ operating systems.
Depending on your operating system and individual settings this