Operating instructions
132
Installation
SAB 160 A1
GB
MT
To avoid function disturbances the installation angle should be less than 30°. ■
Do not install the device in a location where it will be subjected to high ■
temperatures (i. e. direct sunlight or heating vents), heavy contamination and
strong vibrations.
In the e
vent that changes to the vehicle are necessary contact your vehicle ■
dealer/qualifi ed radio installation facility.
Installing the device into the ISO duct
Pull the installation bracket ♦
48
and the bezel frame
47
from the device’s
housing.
Place the installation bracket into the ISO mounting duct. ♦
Bend the tabs on the installation bracket with a scr
ew
driver so that the ♦
bracket is fi xed fi rmly into the mounting duct (see diagram).
Check to make sure that the bracket is securely fi xed. ♦
Connect the ISO socket block of the device with the two ISO plugs on your ♦
vehicle.
Connect the antenna cable from the vehicle antenna to the antenna sock
et ♦
on the device.
Feed the microphone unit cable into the aper
ture and connect it to the ♦
microphone unit socket. Run the cable in such a way that the microphone
unit can be secured in the vehicle interior later
, see also the section “Using
the microphone”.
Contingently connect the audio cinch cable of an external amplifi er to the ♦
LINE OUT socket
40
on the device.
Contingently connect the audio cinch cable of an external subwoofer to the ♦
yellow cinch socket SUBWOOFER
38
on the device.