Operation Manual

123
SAR 28 A1
GB
CAUTION
Possible damage to the cable!
► To avoid damage, observe the position of the cables when sliding the
device into the bay. There is a fi re hazard if cables are damaged!
♦ Carefully push the device into the installation bracket
30
until it locks into
place.
♦ After all the connections have been established, press the RESET
22
button
for about 6 seconds with a ballpoint pen or other sharp object.
♦ Attach the face plate as described under “Installing the face plate”.
Removing the device
To remove the installed device, proceed as follows:
♦ Insert the right and left keys
31
into their respective slots on the sides of the
device. Ensure that the elevations on the spanners are facing outwards
(The tabs are now bent back).
♦ Pull the device out.
IB_42775_SAR28A1_LB1.indb 123IB_42775_SAR28A1_LB1.indb 123 22.10.13 16:0722.10.13 16:07