Operation Manual

SilverCrest SBB 850 D1
English - 19
 Now re-insert the baking tin (8) into the automatic bread maker.
 Close the cover (2).
 Insert the mains plug into a power socket and switch on the main switch (5). You hear a beep
and the display indicates programme number 1 with the corresponding baking time.
 Select the desired programme by pressing the programme button once or repeatedly.
Each press of the button is confirmed with a beep.
 Select the bread weight using the button .
 Select the browning level using the button by moving the arrow on the lower edge of the
display to the desired browning level. The "Quick" setting is also possible here. This reduces
the rise time of the dough.
 It is not possible to set the browning level for programmes 9, 10, 11, 12, 13,
14 or 16.
 The "Quick" function is possible only for programmes 1, 2, 3 and 4.
 The weight setting is not possible for programmes 9, 10, 11, 12, 13, 14, 15
or 16.
 With the timer function, you can now set the time when baking is to end if necessary (not
possible for programmes 9, 11, 13, 14 or 15).
12.2. Starting programme
Press the start/stop button to start the desired programme. The individual programme steps are
now executed in sequence.
Some programs start with a preheating phase (see programme sequence table). The
dough hooks (7) do not move during this phase. This is not a fault.
You can observe the programme sequence and the individual work steps through the viewing
window (1) in the cover (2).
Never open the cover (2) during the rising or baking phase to prevent the bread from
collapsing.
12.3. Remove function
This function allows you to remove the dough hooks (7) before the baking phase. This is not
mandatory, but has the advantage that the unaesthetic holes in the finished bread are slightly
smaller because they are caused only by the thin shafts. The bread is no longer torn by the dough
hooks (7) when removing it from the baking tin (8) and is also easier to remove.
Proceed as follows:
 During the 2nd rising phase, 10 beeps sound and "RMV" flashes on the display .
 Press the start/stop button to pause the programme sequence for 10 minutes.
 During this 10-minute pause, the remaining programme time flashes on the display .