Operation Manual

SilverCrest SBB 850 D1

English - 21

13. Maintenance / cleaning

13.1. Maintenance

ARNING! Servicing is necessary if the automatic bread maker has been damaged

or if liquids or objects have penetrated the housing, if the automatic bread maker has

been exposed to rain or moisture or if it does not work properly or has been dropped. If

smoke is produced, or there are any unusual sounds or smells, switch off the automatic

bread maker immediately and remove the mains plug from the socket. In such cases, the

automatic bread maker should not be used until it has been inspected by authorised

service personnel. Only have qualified personnel carry out the servicing on the device.

Never open the housing of the automatic bread maker.

You can obtain information on spare parts via our service hotline. (see section 18

"Warranty and servicing advice")

13.2. Cleaning

DANGER! Remove the mains plug from the socket before cleaning as there is a risk of

an electric shock!

DANGER! The automatic bread maker must not be immersed in water! This poses a

risk of an electric shock and short circuit.

DANGER!

ait until the automatic bread maker has cooled down completely.

Otherwise, there is a risk of burns!

Device parts and accessories of the automatic bread maker are not dishwasher-proof. Do not use

any chemical, cleaning solvents or strong detergents to clean the automatic bread maker. You thus

avoid damage to the automatic bread maker and cleaning residues in the next breads. To clean the

device, proceed as follows:

Device housing, cover and baking compartment

 First, remove the dough hooks (7) and the baking tin (8).

 Now remove all residue from the baking compartment with a damp cloth or soft sponge.

 Then clean the cover (2) and the device housing also with a damp cloth or soft sponge.

 Now dry the baking compartment, the cover (2) and the device housing thoroughly with a soft,

dry cloth.

Baking tin, dough hooks and other accessories

The surfaces of the baking tin (8) and dough hooks (7) have a non-stick coating. To ensure this non-

stick coating continues to work, do not clean the device with any aggressive or abrasive cleaning

agents or any objects that could scratch and damage the surface.