Operation Manual

SDBS 2400 A1

│

NI │ 13 ■

Steam ironing

1) Press the On/Oﬀ button 0 to turn the appliance on. The indicator lamp

integrated in the On/Oﬀ button 0 lights up and the "max" steam indicator

lamp 3 ﬂashes.

2) Turn the temperature control  to set the required ironing temperature. The

temperature control  must be set to a minimum of

to produce steam.

3) The heat-up indicator lamp  lights up during heating. As soon as the heat-

up indicator lamp  goes out, the set temperature has been reached.

4) Press the steam strength 6 button to set the required steam strength:

– If the "max" steam indicator lamp 3 is lit up, a lot of steam will be

produced.

– If the "eco" indicator lamp - is lit up, less steam will be produced.

As soon as the "eco" - or "max" 3 indicator lamps light up continuously

(depending on the setting) you can start steam ironing.

5) While you are ironing, you can now press and hold the steam button  to

continuously spray steam onto the goods to be ironed from the sole of the

iron . Release the steam button  to stop producing steam.

NOTE

When you press the steam button , it can take a few seconds until steam is

issued from the sole of the iron .

6) Put the iron down on the base station placement area  after ironing.

Set the temperature control  to "min".

7) Press the On/Oﬀ button 0 to turn the appliance oﬀ. The indicator lamp

integrated in the On/Oﬀ button 0 and the "eco" - or "max" 3 steam

indicator lamps (depending on setting) will go out.

8) Disconnect the plug from the mains socket.