Operation Manual

■ 44
│
GB
SDM 1500 B2
2) Press the “Handle” release button  and flip the handle upwards so that it
clicks into place.
3) Run the cable through the notch 0 on the rear of the handle so that the
cable does not hang down into the working area.
4) Insert the plug into the mains power socket.
5) Set the on/off switch 1 to “I”. The on/off switch 1 lights up, the red
POWER control lamp  flashes.
6) Use the MODE button ! to select the desired level of steam generation:
– Press 1 x: low steam level, green control lamp 3 lights up.
– Press 2 x: high steam level, red control lamp - lights up.
– Press 3 x: no steam, standby, POWER control lamp  lights up.
NOTE
► We recommend the high steam level especially for moisture- and heat-
resistant floor coverings, such as tiles.
► We recommend the low steam level especially for moisture- and heat-
sensitive floor coverings, such as parquet flooring.
7) Wait around 30 seconds while the appliance heats up.
8) Press the “Steam” button .. The appliance starts generating steam and,
after a short time, steam is emitted through the pad .
9) Wipe over the desired area.
If the water tank  becomes empty during use:
NOTE
► Once the water tank  has been pumped empty, the pump will continue
running a little while until the empty water tank  is indicated by the simul-
taneous flashing of the red control lamp “high steam level” -, the green
control lamp “low steam level” 3 and POWER control lamp .
– Press the “Steam” button. again to stop steam production.
– Set the on/off switch 1 to “O”.
– Remove the water tank , fill it and replace the water tank  as
described in the section “Filling with water”.
– Set the on/off switch 1 to “I”.
– Select the desired steam level as described above and press the
“Steam” button ..