CV_56986_SDRB1000A1_LB6.qxd 05.08.2010 11:24 Uhr Seite 1 Steam Brush SDRB 1000 A1 6 Steam Brush Operating instructions KOMPERNASS GMBH BURGSTRASSE 21 · D-44867 BOCHUM www.kompernass.com ID-Nr.
CV_56986_SDRB1000A1_LB6.qxd 05.08.
IB_56986_SDRB1000A1_LB6 06.08.2010 11:04 Uhr CONTENT Seite 1 PAGE Safety instructions 2 Intended Use 3 Technical data 3 Items supplied 3 Description of the appliance 3 Before the First Usage 3 Operation 4 Filling with water...............................................................................................................................4 Attaching/detaching the brush attachment ...................................................................................
IB_56986_SDRB1000A1_LB6 06.08.2010 11:04 Uhr STEAM BRUSH Seite 2 • Use only the ironing temperatures given in the care instructions for the material, or those suitable for it. Otherwise, you could damage the textiles. Should care instructions not be given or known, start with the lowest temperature setting. Safety instructions Risk of personal injury! Risk of electrical shocks. • When the appliance is hot, grasp it only by the handle.
IB_56986_SDRB1000A1_LB6 06.08.2010 11:04 Uhr Items supplied • NEVER use the appliance adjacent to water contained in a bath, shower, wash basin or other vessels. The proximity of moisture presents a danger, even when the appliance is switched off. • You may not open the appliance housing. Permit only authorised technicians to repair a defective appliance.
IB_56986_SDRB1000A1_LB6 06.08.2010 11:04 Uhr • Fill the water tank 1 with water (See chapter "Filling with water"). • Insert the power plug 7 into a correctly installed and earthed mains power socket. • Hold the steam brush horizontally. • Place the temperature regulator 3 at the position "MAX". • Heat the steam brush up at the highest setting for a few minutes. By doing this you will clear production residues from the sole 0 of the appliance.
IB_56986_SDRB1000A1_LB6 06.08.2010 11:04 Uhr • Close the water fill opening 2 to the water tank 1. Ensure that the lug on the water fill opening 2 sits in the indentation on the lid. Only in this way is the water tank 1 properly closed. • Replace the water tank 1 back onto the appliance. The water tank 1 must audibly engage with the unlocking device for the water tank 4. Seite 5 • By pressing the steam blast button 8 you can now produce jets of steam. The appliance is now ready for use.
IB_56986_SDRB1000A1_LB6 06.08.2010 11:04 Uhr Note: Seite 6 Washing label Type of material Temperature regulator 3 Chemical fibres, • (low e.g. viscose, temperature) polyester Should you press the steam blast button 8 whilst the heating-up control lamp 5 is glowing the result will be condensed water instead of steam, and water will drip from the sole of the iron 0. Silk, Wool • Leave the garment on the clothes hanger to cool down before putting it on.
IB_56986_SDRB1000A1_LB6 06.08.2010 11:04 Uhr Seite 7 Storage • If you want to put the appliance down during use, fold out the stands 9 to the front and place the appliance on them. When you are ready to reuse the appliance, simply fold the stands 9 back to the rear. Attention! Remove the plug 7 from the power socket and allow the appliance to cool down before putting it into storage. Risk of fire! After using the steam brush • Place the temperature regulator 3 at the position "MIN".
IB_56986_SDRB1000A1_LB6 06.08.2010 11:04 Uhr Disposal Seite 8 The warranty period will not be extended by repairs made under warranty. This applies also to replaced and repaired parts. Any damage and defects extant on purchase must be reported immediately after unpacking the appliance, at the latest, two days after the purchase date. Repairs made after the expiration of the warranty period are subject to payment. Do not dispose of the appliance in your normal domestic waste.