Operation Manual

SilverCrest SFG 8000 B1
English - 45
8.3. Installing/removing the belt clip
8.3.1. Installing the belt clip
Insert the belt clip into the guide located at the handheld transceiver
back panel. The belt clip must click into place.
8.3.2. Removing the belt clip
To remove the belt clip from the handheld transceiver, use your
finger to release the belt clip lock (see the arrow). Once unlocked,
slide the belt clip upwards out of the guide.
(The figure is representational)
8.4. Connecting the earphones
You can use your handheld transceivers with suitable earphones (not supplied). The earphones receptacle
[3] is located behind a protective cover.
Only use earphones with a 2.5 mm jack connector, microphone and PTT button. You
can purchase suitable earphones from a specialist electronics retail outlet.
WARNING:
Before connecting the earphones, you must reduce the sound volume (see page 46),
otherwise you risk damaging your hearing due to the high earphones level.
1. To connect the earphones, open the rubber cover that protects the earphones receptacle [3].
2. Insert a 2.5 mm jack-type earphones plug into the earphones receptacle [3].
When using the earphones, the IPX2 protection against vertically falling drops of
water with tilted enclosure is not guaranteed.
The PTT button on the earphones works in exactly the same way as the PTT button
[12] on the handheld transceiver. When you use the PTT button on the earphones,
speak into the microphone on the earphones.