Operation Manual

SilverCrest SGKT 50 A2
46 - English
Handset locator
This features lets you locate your handset if you have misplaced it. While the base is in standby
mode, press the Locator button [25]. The handset emits a tone for approx. 30 seconds and the Call
LED [13] flashes. The locator ring will sound even if the ringtone has been disabled.
To disable the tone and the flashing Call LED [13] press any button on the handset.
Troubleshooting
Handset does not work / blank
display
 Batteries inserted incorrectly - insert the rechargeable
batteries with the correct polarity.
 Batteries are flat - recharge the batteries.
The antenna icon is flashing  Handset out of range – take the handset closer to the
base.
 Base has no power – check the base power supply.
No ringtone from handset or
base
 Switch the ringtone back on.
No ring or dial tone for outgoing
calls
 The phone cord is defective.
The time and date display flash
on the base
 Time and date have not been entered. Enter the time
and the date.
 The power supply has been interrupted. Enter the time
and the date again.
When using the pulse dial mode with a PBX, it is possible for malfunctions to occur.
This is because the PBX misinterprets the dial pulses. Switch to tone dial mode.