Operation Manual

SIKP 2000 E2
GB│IE│NI│CY │ 15 ■
PROBLEM POSSIBLE CAUSE
POSSIBLE
SOLUTIONS
E5 is shown on the
display 0.
The appliance has overheated.
Disconnect the plug from
the mains power socket
and wait until the appli-
ance has cooled down. If
the problem should persist,
please contact Customer
Services and specify the
error code.
E6 is shown on the
display 0.
The electronics have
overheated.
Check to see whether the
fans on the bottom of the
appliance are working
correctly and whether they
can take in a sufficient
volume of air.
Disposal of the appliance
Never dispose of the appliance in your normal domestic waste.
This product is subject to the provisions of European Directive
2012/19/EU.
Dispose of the appliance through an approved disposal facility or your municipal
waste facility. Please observe the currently applicable regulations. Please contact
your waste disposal centre if you are in any doubt.
Your local community or municipal authorities can provide information on how to
dispose of the worn-out product.
Notes concerning the EC Declaration of
Conformity
This appliance complies with the essential requirements and
other relevant provisions of the European Electromagnetic
Compatibility Directive 2014/30/EU, the Low Voltage Direc-
tive 2014/35/EU as well as the ErP Directive 2009/125/EC,
Regulation No. 66/2014 Annex I, Sections 2 and 2.2.
The complete original Declaration of Conformity is available
from the importer.